cavity wall
英 [ˌkævəti ˈwɔːl]
美 [ˌkævəti ˈwɔːl]
n. (有保暖作用的)空心墙,夹壁墙
牛津词典
noun
- (有保暖作用的)空心墙,夹壁墙
a wall consisting of two walls with a space between them, designed to prevent heat from escaping- cavity wall insulation
空心墙隔热
- cavity wall insulation
柯林斯词典
- N-COUNT (隔音或防寒的)空心墙,夹层墙
Acavity wallis a wall that consists of two separate walls with a space between them. Cavity walls help to keep out noise and cold.- ...cavity wall insulation.
空心墙隔音材料
- ...cavity wall insulation.
英英释义
noun
- a wall formed of two thicknesses of masonry with a space between them
双语例句
- Insulate your home. Cavity wall insulation can cut heat loss through the wall by up to 60 percent.
房屋隔热可以利用空心墙来减少热能损耗,降幅高达60%。 - This paper has a deep research on thermal resistance of cavity wall.
对夹芯墙热工性能进行了深入研究。 - Cavity wall masonry structure is a kind of special structure, because of its simple construction, low cost, so long in many of our relatively low level of economic development are widely used in many areas.
空斗墙砌体结构作为一种比较特殊的结构形式,由于其施工简便、造价低廉,因而长久以来在我国许多经济发展水平相对较低的地区得到广泛的采用。 - A ( test): after being eroded through acid, the cavity wall was spread with EM dental adhesive, then filled with silver amalgam.
A组:经酸蚀后在洞壁周围涂以薄层EM粘结剂,吹匀随即以银汞合金充填。 - The Strength of Sand Mold for Vacuum Evaporation Pattern Casting ( VEPC) and the Moving of Cavity Wall
负压实型铸造砂型强度及型壁移动的影响因素 - After entering the chamber, because of edge effects by the cavity wall, the flow rate of blank uneven, showing a distinct layered flow.
在进入腔体以后,因边部受到腔体壁的影响,坯料的流动速率不均匀,可见明显的分层流动。 - Restoring force of small concrete hollow block cavity wall
混凝土小型空心砌块空腔墙体的恢复力试验研究 - One is that the same to that of the cavity wall. The other is that the pressure of equilibrium radiation field is only connected with the system equilibrium temperature.
得到两个结沦:(1)平衡辐射场内部的压强与腔壁受的压强相同:(2)平衡辐射场的压强只与系统平衡时的温度有关,与其它性质无关。 - Research and finite element analysis on the steel frame structure with new infilling cavity wall
新型砌体复合填充墙钢框架体系试验研究及有限元分析 - Fuzzy optimal design facing cavity wall thickness of large-scale die casting mold
面向大型压铸模型腔壁厚的模糊优化设计
